SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD
purchased this a few months ago from RKJ when he was doing his recent run of throwback bodies, he made 3 midblocks, this was the only full size one, why a fullsize? because it was for a TJD pneumatic assist, which cant go on a mini, and i have a thing for mid and half blocks. also this one is fully 2k spec, including the valve (9/16ths) i realized none of the pics show the front
i got a new body, so that means this one can be released for someone else's project
there's only one "flaw" on the feedneck you can see there was an alignment issue that got cleared up before anything went too wrong, but it did cut to the minimum of the groove for the feedneck in one spot. i can say though
1) it will be covered by the feedneck when finished, so you wont see it
2) it makes the feedneck a TON easier to put on because you have a "starting point" to get it over the first part
3) it doesn't affect the performance of the clamp at all
its raw, as you see it, and im asking what i paid for it, $300
purchased this a few months ago from RKJ when he was doing his recent run of throwback bodies, he made 3 midblocks, this was the only full size one, why a fullsize? because it was for a TJD pneumatic assist, which cant go on a mini, and i have a thing for mid and half blocks. also this one is fully 2k spec, including the valve (9/16ths) i realized none of the pics show the front
i got a new body, so that means this one can be released for someone else's project
there's only one "flaw" on the feedneck you can see there was an alignment issue that got cleared up before anything went too wrong, but it did cut to the minimum of the groove for the feedneck in one spot. i can say though
1) it will be covered by the feedneck when finished, so you wont see it
2) it makes the feedneck a TON easier to put on because you have a "starting point" to get it over the first part
3) it doesn't affect the performance of the clamp at all
its raw, as you see it, and im asking what i paid for it, $300
Comment