Nelspot 007s

[Hobbes]

SOLD Nelspot #1 (with pump handle) - Has chips in the finish but is clean and works without leaks. It's currently shooting around 200 so it may need springs swapped out. It has a 12 gram held in by a screw on the side to act as the ball stop. Asking $120 shipped.

Nelspot #2 - Also has chips in the finish but is clean and working without leaks. I believe this one didn't have a slot to drop the hammer out so one was added. This will need something to act as a ball stop in the top tube. It was shooting 220 when I tested it. Asking $100 shipped.

[Riot]

Someone buy these before my game!

[GanonsGrin]

Just fyi, a dowel rod with tank orings on it will fit nice and snug in the front of a Nelspot to act as a makeshift ball stop. No mods needed to either, although I can’t recall which size dowel I used because it’s been a while ago.

[SPSheep]

I’ve got an indoor pistols only game coming up, so I guess it was meant to be! PM’d on the one with a pump handle.

[The Great Equalizer]

SPSheep Chicago Screws are what I've always seen used for the ball-stop and what I used when I refurbished a 007

https://www.amazon.com/dp/B00355AN4U/?coliid=I2K5746U7JQJD2&colid=2D9NHYTJ4N7RK&psc=1&ref_=list_c_wl_lv_ov_lig_dp_it

That's not the right length, you'll have to measure the top tube. I found mine at the local hardware store.