I used to be on this forum pre-hack, but had stopped coming around a while before everything went down. I was able to make a new account with my same user name for those who may remember me.
Around 2012 I purchased this as a full length kp2 that had been modified with a spring feed, palmer's quick change, and the brass block on top of the barrel as pictured (possibly a brettg mod). After receiving it I had the stock cut down and invested in a longer pump handle, delrin bolt, and feed plug with a retainer. The pump arm is custom made by me to get the shortest possible throwing distance. I put a 12g through recently and it holds air and cycles just fine. I plan on tearing it down (except for the valve) and giving it one last cleaning before letting it go.
This marker was my main shooter for 2-3 years, however, I consider it to be in pretty good cosmetic condition. It has been stored in a padded case indoors for the last 7 or so years.
The following will also be included:
KP valve tool
spec ops barrel bag (nice and wide to fit around the barrel and end of the pump handle)
14 face seals. IIRC, these were newly manufactured 2012-2015.
*kp valve insta-pierce assembly- This is a custom insta-pierce assembly made by a machinist friend of mine. As far as I can remember, when installed it did hold air, however, it was difficult to get a good pierce on a 12g using the quick-change rod alone and I went back to the stock shoot-to-pierce valve. The possible remedy that I thought of would be to drill a hole into the quick-change knob and carry an allen wrench to be able crank down on the 12g, but I was unwilling to molest the quick change knob. I stopped playing regularly soon after.
$400 paypal shipped obo **SOLD**
Around 2012 I purchased this as a full length kp2 that had been modified with a spring feed, palmer's quick change, and the brass block on top of the barrel as pictured (possibly a brettg mod). After receiving it I had the stock cut down and invested in a longer pump handle, delrin bolt, and feed plug with a retainer. The pump arm is custom made by me to get the shortest possible throwing distance. I put a 12g through recently and it holds air and cycles just fine. I plan on tearing it down (except for the valve) and giving it one last cleaning before letting it go.
This marker was my main shooter for 2-3 years, however, I consider it to be in pretty good cosmetic condition. It has been stored in a padded case indoors for the last 7 or so years.
The following will also be included:
KP valve tool
spec ops barrel bag (nice and wide to fit around the barrel and end of the pump handle)
14 face seals. IIRC, these were newly manufactured 2012-2015.
*kp valve insta-pierce assembly- This is a custom insta-pierce assembly made by a machinist friend of mine. As far as I can remember, when installed it did hold air, however, it was difficult to get a good pierce on a 12g using the quick-change rod alone and I went back to the stock shoot-to-pierce valve. The possible remedy that I thought of would be to drill a hole into the quick-change knob and carry an allen wrench to be able crank down on the 12g, but I was unwilling to molest the quick change knob. I stopped playing regularly soon after.
$400 paypal shipped obo **SOLD**
Comment