Board Swaps

[Jordan]

How'd you wire the eyes? Specifically, which wires to what spot? I want to run a reflective eye on a project but have no idea what wires do what on an Eblade eye.

[Roger7pball]

How'd you wire the eyes? Specifically, which wires to what spot? I want to run a reflective eye on a project but have no idea what wires do what on an Eblade eye.

To be honest I haven’t been home enough recently to touch this project in a few weeks. So I can’t say 100% how I wired it is correct, but should be. I’ll check next weekend.

I cross referenced the 2 pictures below.

[ThatDude812]

Would you be up for installing one of these boards in an Eblade for me once you get yours all ironed out? I also would love to know more about the rainmaker board in the Autococker if it’s not much trouble.

[CavemaN]

I know this is a little old…

Roger, how’d you go about the swap on the blind Viking? Did you drill for eyes at the bottom of the breach?

[Roger7pball]

I know this is a little old…

Roger, how’d you go about the swap on the blind Viking? Did you drill for eyes at the bottom of the breach?

No worries. That Viking stayed blind, I didn’t do any drilling.

For the board swap I just soldered female JST connectors to the Morlock board and mated up the trigger, solenoid, battery, on/off switch, and rear LED.

[Frmrspec]

Did you ever get it to successfully run an autococker? I just milled my Excalibur and will be making a single trigger eblade frame to run it because I know those work amazing for closed bolt logic…my previous attempts at closed bolt operation using earlier morlocks were absolute failures

[CavemaN]

No worries. That Viking stayed blind, I didn’t do any drilling.

For the board swap I just soldered female JST connectors to the Morlock board and mated up the trigger, solenoid, battery, on/off switch, and rear LED.

Awesome man, I appreciate the feedback. I’ll follow these steps and probably reach out to you for further guidance. If I go the Morlock route on my blind Viking. Thanks

[Roger7pball]

Did you ever get it to successfully run an autococker? I just milled my Excalibur and will be making a single trigger eblade frame to run it because I know those work amazing for closed bolt logic…my previous attempts at closed bolt operation using earlier morlocks were absolute failures

Yeah there’s a video in this thread of it running an autococker. But I only ran it that way for a bit before swapping to a sci fi board I got for a good deal.

You shouldn’t have an issue running a closed bolt marker. At least with the mk3 or newest board. I’ve run them in a shoebox Shocker and an autococker.

[CavemaN]

Roger, still have any of the clear 45* grips?

[Roger7pball]

Roger, still have any of the clear 45* grips?

I’m sure I do, let me take a look after work tomorrow and I’ll shoot you a PM.

[CavemaN]

I’m sure I do, let me take a look after work tomorrow and I’ll shoot you a PM.

Sweet