3D printer Calibration: the ultimate guide ... By: Teaching Tech
Hello MCB,
Printer tuning can be a bit complicated/overwilling when you are starting and troubleshooting temperature/speed can be long and frustrating ...
Thanks to Teaching Tech, we now have a simple approach that is accessible to everyone.
I have been following this project for a bit, and the newer upgrades/improvements are absolutely phenomenal!
Teaching Tech 3D Printer Calibration
Here is a quick overview of the newest revision:
Please post if you have any trick or info.
Hope everyone can get good information from this.
Thanks,
X
Printer tuning can be a bit complicated/overwilling when you are starting and troubleshooting temperature/speed can be long and frustrating ...
Thanks to Teaching Tech, we now have a simple approach that is accessible to everyone.
I have been following this project for a bit, and the newer upgrades/improvements are absolutely phenomenal!
Here is a quick overview of the newest revision:
Please post if you have any trick or info.
Hope everyone can get good information from this.
Thanks,
X