I got an ender5 and I'm running Cura 4.7 as my slicer.
other mods:
Glass bed with Elmers glue
Parameters
eSun PLA pro
heating the end at 187c
bed at 55c
6.5mm retract
everything else is pretty much default from cura.
I am having an issue with prints sticking to the bed especially off center from the bed. Now if this was a cnc mill I could probably figure out what I need to do but this 3d printing stuff is still pretty new so I'm not sure what parameters I should be looking at tweaking. So can anyone here point me in the right direction.
other mods:
Glass bed with Elmers glue
Parameters
eSun PLA pro
heating the end at 187c
bed at 55c
6.5mm retract
everything else is pretty much default from cura.
I am having an issue with prints sticking to the bed especially off center from the bed. Now if this was a cnc mill I could probably figure out what I need to do but this 3d printing stuff is still pretty new so I'm not sure what parameters I should be looking at tweaking. So can anyone here point me in the right direction.
Comment