As always my dremel/drill work is haggard.
1. Drilled holes to fit 10-32. Missed the mark on the rear frame hole being done cleanly but the recess would have basically acted as a guide for the 10-32 hole
2. Shave the front off to fit behind the vasa.
3. Flatten back, drill/tap for 10-32 beavertail
cheap solution for a single hinge pump frame with autotrigger.
I recommend getting a empire sniper a/t arm nub. If using the ccm a/t nub i recommend a drop of loctite and allowing the autotrigger arm/cam some wiggle room (not toghtening so hard)
1. Drilled holes to fit 10-32. Missed the mark on the rear frame hole being done cleanly but the recess would have basically acted as a guide for the 10-32 hole
2. Shave the front off to fit behind the vasa.
3. Flatten back, drill/tap for 10-32 beavertail
cheap solution for a single hinge pump frame with autotrigger.
I recommend getting a empire sniper a/t arm nub. If using the ccm a/t nub i recommend a drop of loctite and allowing the autotrigger arm/cam some wiggle room (not toghtening so hard)
Attached Files