Been wanting to do this for awhile, part of the reason why I wanted a mill was for making my own pump mag since rails are such a pain to get a hold of.
Took me a couple hours to do this one going in cold, but should go a lot smoother for my next one. Tried milling the ramp, but didnt really work out how I planned, so I just used the dremel for that part and that was a lot easier than I figured it would be.
You can see a couple scratch marks on the rail surface on the second pic, I used my calipers to mark where the angled ramps start and end so I'd know where to stop on the manual mill.
Next on my list is to mill a ule body for pump.
Took me a couple hours to do this one going in cold, but should go a lot smoother for my next one. Tried milling the ramp, but didnt really work out how I planned, so I just used the dremel for that part and that was a lot easier than I figured it would be.
You can see a couple scratch marks on the rail surface on the second pic, I used my calipers to mark where the angled ramps start and end so I'd know where to stop on the manual mill.
Next on my list is to mill a ule body for pump.