I've been rebuilding an AutoMag fitted with a retro valve and a level 10 bolt and it's been nothing but trouble.
The latest issue is with the bolt.
After a bit of test firing it started leaking a lot of air down the barrel. It had me scratching my head for quite some time before I noticed that lower part of the bolt pin was missing (it was inside the air chamber). From the looks of it this part is pressed in with Locktite or something similar.
My question is had anyone managed to salvage a level 10 bolt with this issue. I was thinking of using Locktite 620 which is a very good retaining compound and I have it to hand.
The latest issue is with the bolt.
After a bit of test firing it started leaking a lot of air down the barrel. It had me scratching my head for quite some time before I noticed that lower part of the bolt pin was missing (it was inside the air chamber). From the looks of it this part is pressed in with Locktite or something similar.
My question is had anyone managed to salvage a level 10 bolt with this issue. I was thinking of using Locktite 620 which is a very good retaining compound and I have it to hand.
Comment