Cerakote a barrel

[iamthelazerviking]

I may want to have a stainless barrel done in a solid black but worry about the internal bore getting messed up if something gets through the port holes. I'm not super familiar on the process but I would imagine someone who knows what they're doing would do it right...right?

[Cyberpyr8]

Not if they know what they're doing! It should be fine.

[Chuck E Ducky]

They block that all off before they spray if done properly

[Alexndl]

I think shooter311 had a complete mag and barrel cerakote by Barefoot
wondering the same thing since I am thinking about it (but on an aluminum barrel)

[iamthelazerviking]

I'd definitely be going with Barefoot if I decide to do it

[Chuck E Ducky]

Then you will be fine. Just make sure you tell them to insure the barrel bore stays untouched.

[shooter311]

The first marker I had barefoot coat. He told me he would spray the inside and out of the barrel and assured me it would be fine. I told him I would feel a lot better if he taped it all off. So he did. After feeling the cerakote is seemed actually pretty slick. So I had him do a micromag with a rifled armson barrel and he coded the inside and I haven't had any problems with that at all. So it's up to you which route you would want to go.

[Chuck E Ducky]

That Armson barrel is large bore isn’t it so it probably helps it functionally wise.