Anyone out there build an RT setup like fosnacht? Not sure if he will make anything for anyone anymore.
-
-
Pretty sure he has the market cornered on these.
I always thought they were the coolest thing you could do to a Cocker but I don't think I could use one, I've lost my Cocker mojo. -
Haha, yea, I would like to see if he could build me one but I don't know if he will build any. Not sure why thoughComment
-
Have you talked to him about it? Might be worth asking...Comment
-
Iβve done one but it always shook itself to pieces. Keep your eyes peeled for a bps reflex kit, they pop up every now and then.Comment
-
The linkage to the 3/4 way that I converted to a 2/3 way valve to control the piston behind the trigger was the weak point. -
Did you swap it to a normal 3 way with one hole plugged? I did that, made aluminum slotted rods with just a threaded hole for a 6-32 screw that went into the pocket of the three way's rod. Stops it from bouncing out of time, and is a lot lighter. Works great. It is trickier to set up with the stock reflex front blocks. Mine are milled for easier access.
The stock 3 way that comes on reflexes were easily my least favorite part of the set up. Those and the delrin tangs were just awful. -
yes, just plugged one hole. I used one of the old brass 3 ways with the c-clips to keep the rod in place. I made a slotted piece of aluminum that was attached to the three way rod. I used a delrin block with a dovetail and set screw to attach the 3 way to the sight rail and a bolt threaded into the top of the back block to move the slotted piece of aluminum/3way shaft at the ends of travel. Not a pretty creation but it did work even if only for short periods of time.
-
-
I have asked him but he doesn't seem to be making them now. Not sure.Comment
-
A reflex kit would great. They are also hard to come byComment
-
Y'all rang? I may have just gotten a dozen or so front blocks back from emachineshop. And the reason I am hesitant to do runs is that they just take a ton of time to do.
That said, I am likely using the 12 blocks that I just did to build more out on gunfighter frames. The prototype is at ano, with that block being the last piece that was needed and it's in the mail.
The biggest questions is just whether or not I will knock out full guns.Comment
-
Thank you for joining the conversation! Can I get on a build list for a kit? How does the process work?Comment
-
Have to decide on a few things first --- namely if I am doing kits or full markers. Then I'll know.Comment
-
I am really interested. Where will you post when you decide and slots are open?Comment
-
Will let you know, won't be immediately---I am out of the country a lot in July, and have other stuff that eats paintball time like recruiting for WARSAW for Fulda, doing the website, machining the tungsten cored ICS kits, and the charity stuff.Comment
-
I appreciate it. I will be looking out.Comment
-
Will you post on here or facebook?Comment
-
Probably both?Comment
Comment