What to do?

[Psycho91]

Well as usual I got traded someone else's junk they didn't want to mess with, got a body where the valve nut deformed the valve so I had to knock it out but it scuffed the bore a little bit, is there a way to hone it slightly and just clean it up a bit so no orings grab a random burr


Also they cut a cunt hair to much off of the body when they minied it which is no big deal except my frame won't clear my ID front block when it's all bolted together, I have a benchmark frame currently, while I could just sand the back of the front block a little or even the front of the frame I don't want to go doing that just yet, i was wondering if there are any sliders that have less meat in front of their trigger gaurd that would give me that little extra cunt hair of clearance, of not ill just get a trilogy frame and mod it to fit

[Toestr]

I've put toothpaste on a shop rag then wrapped it around a dowel and put it in a drill. That smoothed out the corrosion in a STBB pistol mag for me.

Sent from my Pixel 4a using Tapatalk

[Psycho91]

Thanks man

[SETHZILLA!]

I've got a original WGP metal slider frame if you're interested in it? It's also much thinner width than then Benchmark frames, and slightly thinner up around the front of the trigger guard.

Sent from my SM-S901U using Tapatalk

[Psycho91]

Hmm I did get offered a mozak retro frame

[Psycho91]

Ok so it seems my scuff is more of a light scratch and the rag and toothpast trick didn't work all that well, what about a flex hone

[Psycho91]

Also what threads are cocker valve nuts I want to chase the threads just to be sure I didn't screw them up knocking the valve out, got the tap some where just don't remember the thread

[Alexndl]

You can check on this thread for your answer
https://www.mcarterbrown.com/forum/p...hread-s-thread

[Psycho91]

Thank you