Seized autococker ball detent

[The Inflicted]

I bought a cheap Trilogy cocker earlier this week and as part of my rebuild found that the ball detent was sticking in the retracted position. Adding some oil helped for a bit but after test-firing the gun the bearing is now totally locked down. I squired some WD-40 on it overnight but this hasn't helped.

I had a spare detent to get the gun running, but are there some good methods to salvaging this one?

[Fossilhead]

I threw mine in a cup with some liquid dawn. Then just pinch the detent a few times and work the soapy mess inside.

Work it for a while and you'll loosen up old bits of paint and shell

[Cdn_Cuda]

I've had a similar experience with the same style detent. Got it unstuck only for it to get stuck again. Just toss it. Actually, that's how I got mine unstuck for a short amount of time! But then it jammed again. Or drill a small hole in the back to you can poke it out.

[Pumpytrilly1]

I tried rubbing alcohol and it seemed to help a little bit. I was planning on trying a simple green soak since its a mild acid.

If that doesn't work I'm going to drill a 1/8 hole in the back side.

[jetenginekyle]

I tried rubbing alcohol and it seemed to help a little bit. I was planning on trying a simple green soak since its a mild acid.

If that doesn't work I'm going to drill a 1/8 hole in the back side.

1/8 would likely be larger than the diameter of the spring

[JeeperCreeper]

I use these:
https://autocockerparts.com/autocock...detent-nickel/

Sometimes it's better to buy a part than to spend hours trying to fix the one you have.

[tyronejk]

Or worse: spending days making a part from scratch rather than just buying a new one.

[Myrkul]

I always just drill a small hole in the back and knock them free.