Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
If you're familiar with the claims/"features" of the Palmer's low turbulence valve, is there any real benefit over the CCM valve? I know the PPS LT has a poofy feeling shot quality though.
I have both of these valves and I like the Palmer’s a little more because of the poof. It seems to operate at a slightly lower pressure than the CCM, but I haven’t experienced noticeable performance increases otherwise.
Have PPS and CCM valves in a couple of my snipers and really can not tell the difference. I tend to just buy CCM lower tube kits for the simplicity and reliability over anything else anymore. That is unless I want to tinker on something then mix and match is the game.
"When you are asked if you can do a job, tell 'em, 'Certainly I can!' Then get busy and find out how to do it." - Theodore Roosevelt
Yeah I have the LT valve already plus Shocktech Phat hammer and set of Inception hammer springs, so it's mixy maychy but can still get a new CCM lower tube at the moment just trying to figure out if it's even worth it and keep what I have
Comment