Replacement Trilogy ram piston?

[lhamilton1807]

welp, I tried straightening my Trilogy's ram shaft by taping & chucking the threads, but the threads just broke right off when I applied minimal pressure. There was a leak from the hex fitting, so I needed to get to the o-ring anyway. Other parts of the ram aren't damaged.

Do I need to buy an entirely new ram? Or will a std shaft like this one work? Or does anyone have one kicking around in their bin of parts?

[Psycho91]

They are stock wgp spec so any stock shaft will work, I have a trilogy shaft I used in an old brass ram I rebuilt

[superman]

That link is to an empire shaft it uses a different shaft and piston head than a standard wgp ram.

I have used trilogy rams available if that is something you need.

[lhamilton1807]

OK, so an STO ram shaft would work?

[Psycho91]

Yes it's still a stock wgp spec ram

[Blackmagic71]

Autocockerparts.com should have them.

[lhamilton1807]

yeah, looked there and they don't have the ram shaft or the ram shaft assembly. I could buy the whole ram but the rest of the parts are good...

[Blackmagic71]

https://www.ebay.com/itm/38768980003...mis&media=COPY

[lhamilton1807]

Thx, I did see that at one point but wasn't sure. superman says he has one, so I may go that route. Or if none of these work out and I REALLY decide I need a project, I could try making my own... but probably not something I need to get into for one ram :P
Amazon.com: uxcell Round Steel Rod, 3.4mm HSS Lathe Bar Stock Tool 100mm Long, for Shaft Gear Drill Lathes Boring Machine Turning Miniature Axle, Cylindrical Pin DIY Craft Tool, 10pcs : Industrial & Scientific

[Blackmagic71]

I missed Superman’s post. Always good to get from another member if you can.

[lhamilton1807]

I’ll probably regret spending time and money on it, but screw it. Gonna try to build one from round bar.

I’ve collected the measurements and if it works I’ll do a write up.