SS-25 Front Block Retention Screw Loctite Help

[Ego10Baller]

Hi folks, I recently purchased a CCM SS-25. It turns out Cockertop got his hands on it at some point and decided it was a good idea to loctite the front block retention screw in (and the cocking rod). I've tried loosening it normally with an allen key, using WD-40 to break it free, and a soldering iron to heat up and break down the loctite. It is still locked in there tight and I don't want to strip the screw.

Would it be a bad idea to use a propane torch on the screw / area to break down the loctite?

I've also reached out to BeardedWorks / Jake to get a quote for him breaking it loose but if it I can avoid shipping the marker body, that would be preferable.

Thank you all for any ideas and help you can provide!

[iamthelazerviking]

Jeez... there's a reason a lot of people don't like the way that guy does things. From what you're describing, he used RED Loctite??

[Ego10Baller]

Apparently he only uses blue from what he told the seller but I'm questioning which blue he used. I use blue all the time on optic mount screws and it breaks free very easily. It's a big time goober move to even loctite in a cocking rod much less the front block screw.

Jake got back to me really quick this morning - I'll probably end up shipping it all to him to have him get it back to where it should be. Sounds like a propane torch isn't a great idea and I'm not sure what else to try that wouldn't otherwise strip the screw.

[Grendel]

Not all "blue" thread lockers are the same and then instead of just a Dot of thread locker many will coat all of the thread which just increases surface area that is locked. It takes just a few minutes to read the recommended methods of using thread locker. One of the reasons I like Vibratite it does a great job of preventing a screw from walking out but never truly hardens so easy to remove when needed.

[cstx_pb]

That's rough. Good luck fixing it. Not sure why someone would need to send a pump to get serviced. They are pretty straightforward. Maybe it was for those "bUtTurr m0ds" this guy keeps going on about... I highly doubt he can get a CCM shooting better than it does stock

[Ecapnation]

People are mechanically dumb

[iamthelazerviking]

That's wild...I once sent CT a pump build to tune and address a specific issue, I told him about it online and also left a note. He didn't address the issue...so I figured it out myself. He also didn't tune the thing well at all. CCM internals, but the IVG was like 6 turns in, WTF? After that experience, I vowed to always do things myself whenever possible.

The only other thing that might work is getting another allen key of the size needed that you can throw away. Put some JB Weld in the socket of the the screw, shove the key in, let it set. I've done this with stripped screws, but obviously this might not work and you would also need a need set screw.

[superman]

I would avoid the jb weld if possible. It would make it harder to remove on my end.

[Ecapnation]

Amateur hour covid techs....

Here's my trick. Get a soldering iron and hold it in the head of the screw if he used low strength locktite that will likely start to break it down some.

[Ego10Baller]

I really appreciate it. I gave that a shot earlier today - left it on for 15 minutes after the soldering iron had heated up for 15 minutes but with no dice. Mine is only a 40 watt Weller iron though so not exactly the highest grade like some of the ones with a temperature readout and all that so maybe it isn't heating up as much as is needed to break down the loctite.

[Ecapnation]

There's always tiny pencil torches ...