I just bought the replacement poppet for the Axe Mini platform from Method. So far I have been able to drop the dwell down to 4.9 (down from 8.0 factory) and it's shooting +/-4 at 285 with my Carbon IC PWR insert barrel and 550PSI PowerHouse reg. It is very consistent and now feels somewhat softer on the shot. It still has the pop to it but not as jarring as stock. I will run it next time I go as my primary and see how well it performs all day, but in testing at the house it does seem to help with performance.
For a $35 upgrade, it is worth the it to try it out. I will do some more testing and come back with a longer term review, but for short term and initial impressions, I think it was a good investment.
Here's some things from the PBN thread on it.
For a $35 upgrade, it is worth the it to try it out. I will do some more testing and come back with a longer term review, but for short term and initial impressions, I think it was a good investment.
Here's some things from the PBN thread on it.
We actually went with a high grade phosphor bronze alloy for better wear characteristics and to adjust the timing a little. It ships with an xring in the rear location as well. We have seen this improve consistency and reliability by a significant margin.
The poppet is really meant to help prolong the service intervals of the engine. if debris is cycled through the engine it can damage the sealing surface and then the whole bolt guide will need replacement. With this, it should be the last poppet needed.
The poppet is really meant to help prolong the service intervals of the engine. if debris is cycled through the engine it can damage the sealing surface and then the whole bolt guide will need replacement. With this, it should be the last poppet needed.
Comment