Hey gang, picked up a classic RT from the BST side with a composite single trigger frame. I replaced all of the orings and my tank output is about 900-950. After the oring change I was able to get a 4-5 shot RT going but I figured the new rings need to break in.
I installed a new level 10 bolt today and new reg piston. The 1.5 carrier leaked so I went with the 1.0 carrier, gold/short spring, and 1 spacer as I got a small amount of bolt stick with a small leak with no spacer. Stuck a squeegee in the breach and it resets like it should with no leaks. Full/fast trigger pulls work fine and shooting 280 with no issue.
Issue is now I can’t get it to RT at all. Does it need to break in more or is something else going on here? Thank you in advance!
I installed a new level 10 bolt today and new reg piston. The 1.5 carrier leaked so I went with the 1.0 carrier, gold/short spring, and 1 spacer as I got a small amount of bolt stick with a small leak with no spacer. Stuck a squeegee in the breach and it resets like it should with no leaks. Full/fast trigger pulls work fine and shooting 280 with no issue.
Issue is now I can’t get it to RT at all. Does it need to break in more or is something else going on here? Thank you in advance!
Comment