A couple questions regarding Resurrection timing. Background info first.
Inception hammer.
I set the LPR where I want it.
Have not sweetspotted the HPR, but it works as it is now. Back burner for now.
Set the 3-way so it works.
Just installed an Inception NOS trigger plate.
It's currently functioning, and I really like the trigger feel/slide. The issue I'm having is getting the sear/hammer to trip sooner. It doesn't trip until almost the rear of the trigger pull. I've adjusted the hammer lug in both directions, but I only have about one full rotation before it either doesn't catch or doesn't trip. Is the adjustment window for these really that small?
I've tried adjusting the 3-way so it will actuate later, but it would leak. I set it so it's just past the point where it doesn't. But any more and it would operate too soon & I'd get some blowback up the feedneck. Again, this seems like a really small adjustment window in conjunction with the hammer lug.
Basically, I want to set it a tad more conservatively to help eliminate short-stroking. I want the sear/hammer to trip sooner. I don't usually short-stroke as it is, but having the sear/hammer trip sooner would help with that & stop the blowback up the feedneck. I just can't figure out how to do it with the small adjustment windows this thing seems to have. What should I start with?
Thank you for reading.
Inception hammer.
I set the LPR where I want it.
Have not sweetspotted the HPR, but it works as it is now. Back burner for now.
Set the 3-way so it works.
Just installed an Inception NOS trigger plate.
It's currently functioning, and I really like the trigger feel/slide. The issue I'm having is getting the sear/hammer to trip sooner. It doesn't trip until almost the rear of the trigger pull. I've adjusted the hammer lug in both directions, but I only have about one full rotation before it either doesn't catch or doesn't trip. Is the adjustment window for these really that small?
I've tried adjusting the 3-way so it will actuate later, but it would leak. I set it so it's just past the point where it doesn't. But any more and it would operate too soon & I'd get some blowback up the feedneck. Again, this seems like a really small adjustment window in conjunction with the hammer lug.
Basically, I want to set it a tad more conservatively to help eliminate short-stroking. I want the sear/hammer to trip sooner. I don't usually short-stroke as it is, but having the sear/hammer trip sooner would help with that & stop the blowback up the feedneck. I just can't figure out how to do it with the small adjustment windows this thing seems to have. What should I start with?
Thank you for reading.
Comment