instagram takipci satin al - instagram takipci satin al mobil odeme - takipci satin al

bahis siteleri - deneme bonusu - casino siteleri

bahis siteleri - kacak bahis - canli bahis

goldenbahis - makrobet - cepbahis

cratosslot - cratosslot giris - cratosslot

Announcement

Collapse
No announcement yet.

Pneucocker 3D printable parts

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Pneucocker 3D printable parts

    I decided to find parts for and build a pneucocker and I'm OCD enough that I couldn't just build the parts I needed with a hack saw so I designed parts and printed them. It took me enough time that I figured somebody else ought to use the stuff if they wanted. So I uploaded everything to thingiverse.

    Included are a blank frame insert, a hole plug, and a couple of smooth triggers with and without stops.

    Frame insert, smooth trigger, and hole plug for a pneucocker build. This will save HOURS of fabricating your own parts. This is the original build thread showing how to do this - http://customcockers.com/forum/showthread.php?52850-Pnuecocker-Build-FAQThis is a good fitting blank insert for the WGP SF trigger frame to build a pneucocker if you're looking to do that. This is way easier and better fitting than the do-it-yourself options everyone else has done. The raised portions around the bolt holes will make the insert sit square inside the frame. Weird, but without them, it is pretty crooked. The indentations on the bolt hols is to make the insert thick enough while maintaining the right thread depth.Also added 2 smooth triggers without the finger separator hump so it is easier to walk the trigger. One with a set screw stop and one without. These triggers are in the same format as the OE trigger with the return stop in the internal mechanism. Also adds a hole on the stop tang so you could tap a #4 hole into which would make the trigger travel adjustable in both directions once a set screw is installed. When tapping, I recommend holding the tang with a pair of pliers to make sure your printed layers don't split. This area is pretty thin because of the space restrictions.Lastly, a good fitting solid hole plug that is really clean and uses the stock screws



    #2
    Cool man!

    Comment


      #3
      That's cool, I posted my own in the 3d printing repository. You should post yours there too!

      Comment

      Working...
      X