I have a Promaster that has a leak on the LP hose on the top fitting of the backside of the noid. Almost certainly because the bend is too great for the length of the hose so it's not grabbing the barb properly. Could also be that I need softer tubing since what's there is super hard now.
Anyway, I was reading the Promaster thread on PBN and there was discussion about both replacing the one solenoid barb with a 90° one and also doing a loop of hose between the barbs. I'm looking to sell the gun so I'd like to put as little as I need into it.
I have some hose from an SP1 already so I figured I'd try the loop. Anyone have pictures of the length required/how to route it? If it comes to it I might see about getting a 90° barb. Does anybody know the size needed for a Humphrey solenoid?
TIA
Sent from my Pixel 4a using Tapatalk
Anyway, I was reading the Promaster thread on PBN and there was discussion about both replacing the one solenoid barb with a 90° one and also doing a loop of hose between the barbs. I'm looking to sell the gun so I'd like to put as little as I need into it.
I have some hose from an SP1 already so I figured I'd try the loop. Anyone have pictures of the length required/how to route it? If it comes to it I might see about getting a 90° barb. Does anybody know the size needed for a Humphrey solenoid?
TIA
Sent from my Pixel 4a using Tapatalk
Comment