Expensive Azodin

[nobbie333]

My SPUMP
First I just want to say thank you to ChoSanJuan and Myrkul for all you help
Now lets start
I started with a Spyder tlr that I sent to BMC Fabrication to get the body rethreaded to autococker because it is cheaper and easier to find autococker barrels plus I have a few

Next I found a trilogy pump kit on ebay and had a friend mill it down to fit better in the spyder he added wrench flats and shorted the thread to fit flush



Pump handle: I asked ChoSanJuan to 3d print a sniper handed found on Thingiverse and I filled the insides with foaming insulation than I added a bushing and insert to thread in the pumping handed to finish the handle off with a back cap of epoxy to seal everything in




The valve: I started with a magnaport and added a cup seal from an empire sniper it gets ride of the fart noise



The factory striker is very hard I asked a machine shop to mill a grove and it too several hours
Or you can just used a factory Azodin pump striker and open the back up a little your done



The Frame: and before final assembly I get the frame drilled for pre and post travel with set screws




Now I am done with this one

[scottieb]

Now that it is cocker threaded how thin is the material around the barrel threading?

What was the cost on that?

[nobbie333]

It is not to bad I think Brandon at BMC Fabrication charges around $20.00 to rethread the body to autococker

[Hobbes]

Pods are supposed to go in your pack, not the tip of your barrel.

[MrKittyCatMeowFace]

does the tube it make Louder or quieter?

[nobbie333]

Much more quieter

[nobbie333]

it is less than .075 deafferents between spyder and autococker barrels