VS3/VS2/RS/RSX Oring Chart

[appleguy]

I bought a VS3, because I’m very curious about the balanced valve setup.
The orings need replaced, as expected. I have the manual, but it doesn’t list Oring sizes, and some of them are too trashed to measure.
I’m also concerned that some of them are metric, but I don’t know if Kingman dropped that habit in their later years.


Know where I can find a list, so I can make sure I get the right ones from the Oring store?

[Toestr]

I asked about this a while back on Facebook and I was told 008 in the internal groove and 009 in the valve pin groove. Someone else also said 006 so I don't know.

Sent from my Pixel 4a using Tapatalk

[appleguy]

That’s a good start. I’m also going to try to rebuild that combo ASA/regulator, so I’m looking for those sizes too.