Stab rebuild

[Killerito]

So have a stab on my micro cocker. Usualy it’s set at around 230-250. Aired it up Yesterday and it dumped 800 psi.
where should I start with the rebuild?

[Flounder]

Most likely the little seal on the reg seat. I would suggest replacing all the seals when you take it apart.

[Killerito]

Might just throw a brand new one on it. I rebuild it less than 2 moths ago. So it might just go on something as a fore grip lol

[Interl0per]

[PaintballTek]

It would either be the -010 on the reg head hex or the reg seat itself causing this. Chances are it's the -010 as the reg seats very rarely fail. You will need a long 3/8" hex driver to remove it and the piston, spring, reg seat, and hex but will come out.

The large piston o-ring is a -112 if you want to replace that as well.

[raptor69r]

The reg seat (flat washer) can be flipped over and it will work. Most likely you need to replaced the 010 oring on the brass hex piece as well.