i purchased a palmer female stabilizer it didnt come with the asa cage mount. does anyone know what weaver base i need for a weaver 1' scope mount for the stab regulator?
-
πTeam Ragnastock π
π Pump Kings π -
A ring for a 1" scope made for a rimfire or airgun sight rail will often mount to a dovetail rail.
Not sure about a weaver base, but for a "standard" grip frame with normal bottom line screw holes it would need 2 holes for a 10-32 screw spaced 3/4" apart.
So after a bit of googling, a #71 base will have the right hole spacing, but the bottom radiused, not flat. Should still mount up, but might look a bit off.
-
I know the rings that were shipping out a few years ago were Talley rings drilled for WGP spec bottomlines with the measurements Fubarius mentioned, I believe they are these or at least these should work Henry Lever Action Scope Mounts (H009, H010, H014, H018, H024)
βComment
-
I'm pretty sure someone had some of these type rings for sale on here recently but i can't find the post now anyone else know?Comment
-
I just bought something close to that it will be here monday.
Attached FilesπTeam Ragnastock π
π Pump Kings πComment
-
-
Are you planning on modifying it to mount as a bottom line? I always poach cheap check-it unimount cagesComment
-
Ill see if it works mondayπTeam Ragnastock π
π Pump Kings πComment
-
Didnt work holes were off by a smidgeπTeam Ragnastock π
π Pump Kings πComment
-
even though i hate to support this sellerAttached FilesComment
-
-
Comment
-
Jonnydread maybe your detents could hitch a ride east with Db1060 's new cage...π...
If it counts for anything, 3 out of the 4 people, that I sent towards PPS, got the needed/wanted item..eventually. π
-
I ended up drilling the holes to the 1β mount thare alittle off but they work.πTeam Ragnastock π
π Pump Kings πComment
Comment