Pro Carbine Spare Parts

[ThinRizzie]

Heard a lot of good things about procarbs when I was looking for my first marker, so when I saw one online for $10 it was an instant buy.

did a clean/ o ring change but couldn’t figure out a bad leak. Gave it to the tech at the field and they’ve had it for a while. They just let me know that it needs a new valve assembly and they can’t source it, so I’m SOL.

does anyone have any clue where I can source parts for this thing? Or an alternative valve that might work? Maybe it uses the same internals as another marker or something?

thanks in advance. I’d really like to fix this thing instead of just buying another one

[$L!mBo]

second
i need a rear spring and back cap
and fresh seals

[SuperAtomic]

RVA back-cap

https://www.ebay.com/itm/314700721396

Seals

https://tippmannparts.com/products/rpm-ok-delx-pl-2591-deluxe-tippmann-pro-lite-oring-kit-also-fits-pro-lite-pro-am-and-68-carbine

[SuperAtomic]

And some fresh, non-rusty screws.

https://www.ebay.com/itm/186534358845

[Toestr]

To my knowledge the drive spring is identical to the 98's.

[Toestr]

The valve is rebuildable.Tippmann uses a flat metal split ring to hold the valve together which is a pain to get off. It's likely the tech considers the whole valve assembly to be a disposable part, but Tippmann does sell the individual components. It's likely both of the 012 orings in the valve went bad. It's very unlikely the cup seal is bad unless the gun is a beat ex rental. Even if it is bad, it uses the same cup seal and brass seat as the 98 and other modern Tippmanns.

Compress the brass plug at the front of the valve until it clears the air inlet and stick a toothpick in to hold it down. Then use a stout pick/thin flathead screwdriver and dig out the split ring (avoid stabbing yourself). Replace the split ring with a 1/2" internal snap ring when reassembling (the flat side of the stamping should face out).