Palmer Stab and Roc Rebuild kits

[docfire]

Palmers PPS ROC/Stabilizer Rebuild kit – Docfire Paintball

[Chuck E Ducky]

Are these new kits or New Old Stock?

Melrosejedi maybe try these see if it fixes your reg creep issues.

[Chuck E Ducky]

Dave has had a ton of issues with his palmers regs lately. He’s rebuilt it a few times I’m wondering if his rebuild kits he’s using are older. This could be a solution for both his regs spiking randomly through out the day. I wonder if the bunna is swelling due to CO2 use. (12g play) I bet these would be less likely to allow co2 to permeate the seals. I tagged him so hopefully he sees this tomorrow. Might explain why the issue comes and goes. Pressure spikes expands the seals if it sits degassed it will eventually leach out and operate normally.

[Jordan]

Urethane is the BEST seal material for the piston oring. I've also run into problems when I use a 010-70d instead of a 90d for the reg seat oring, they seem to creep slowly with the softer oring.

[Chuck E Ducky]

Good to know thanks.

[Melrosejedi]

Thank you chuck, i may consider this as a one last chance for these regulators.thanks jordan for the advice, i may try that also.

[Chuck E Ducky]

Dose the PPS kit you have use black bunna. I bet that why you only see issues when using co2

[Melrosejedi]

Yes, except the piston seal. I reached out to docfire for pricing.

[Chuck E Ducky]

Cool I hope this solves your issue. Palmers are supposed to be the Go 2 for CO2

[gabe]

Good I'm glad someone has these. I rebuild my Micro Rock with a PPS kit and it keeps getting reg creep.

[docfire]

These are new kits that I make $19.99 each

[docfire]

Also If you send me your PPS Stab ill install the kit for, at no extra charge, then test and set your reg.

[Melrosejedi]

Ordered two and hope this fixes the creep issue.