New Brass 'Cocker Detents!

[DocsMachine]

Had a bar of some hex brass laying around, and since I had a similar part set up in the machine, I cranked a few out for you lot.



I know I've been asked for them a couple of times over the years, by guys wanting to keep the vintage/old-skool look to old Snipers and the like, so for those few of you, here ya go!



Pretty limited run, I didn't have a lot of material on hand, so get 'em while you can!

Solid brass with a Delrin ball- as machined, not polished. Asking $20 each plus $4.50 in shipping. PM me here or email to ordering@docsmachine.com

Doc.

[cougar20th]

I'll take a couple. They will go good on the Ole kp3.

[JeeperCreeper]

Could I get those with a steel ball instead?

[DocsMachine]

I'd have to order some, but sure. I have to ask why, though, I hated rusty balls...

Doc.

[JeeperCreeper]

Because I use them "wrong" and use them to hold a ball with the bolt forward. The plastic ones dont hold up.

[Yo soy el Warg]

Oo. I'll take one for my BL cocker.