PGP Spring Kits back in stock on PGP JUNKIES!

[Myfeetupontheground]

After all the work I put into selecting and sourcing the correct springs for this kit, the source for the high tension hammer spring had some delays in re-stocking. But we are all good now! Come check it out!

https://pgpjunkies.bigcartel.com/product/pgp-spring-kit

[JohnB]

Would these work to adjust fps on a Sheridan kp2?

[Myfeetupontheground]

I believe so, but I have never tried it. Might should ask around on MCB to get an answer for sure.

[netsurferdude2]

They would not. K-series springs are longer than P-series.

[Myfeetupontheground]

Thank you for answering that question. I have never had a K-series, but I have seen this question come up allot.

[mooman978]

Do you know where one could find k series springs?

[gabe]

Snagged a set. Interested to see if they help efficiency on my P68 or at least help it pierce a 12g. Either way love supporting a small business.

[gabe]

Awesome, thanks for the feedback on it. Can't wait to give it a try.

[Myfeetupontheground]

MullerTime Thank you for the feedback! Are you pleased with the spring kit? Or is the efficiency change not what you were hoping? Helping with 12g piercing is one of the reasons I went with a lighter valve spring.

[MullerTime]

Sure thing! Yeah, I am happy with the spring kit. It is working well for me. I did keep my stock hammer spring in there because it seemed fine to use and I was getting velocity. The two hammer springs look to me like they should work fine and the heavier one should have plenty of power to get velocity.

I was mainly looking for the lighter valve spring for help piercing the 12gram. I wasn't really concerned with improving efficiency. I think these old sheridans kinda are what they are with the smaller paint today. I've heard you have to drill out the transfer port to get real gains but I am not a sheridan guru.

I had used your face seals in a component valve PMI-1 and it worked fine with the stock springs but the new face seals were a little thicker than what was in my 2 cartridge valve PGP2Ks and they were having trouble piercing the 12 gram. I did cut them down in thickness a bit for them to work in my PGP2ks with the stock springs.

It seems like the face seals would work with the lighter valve spring from your kit without cutting them since the stock valve springs in my PGP2Ks were pretty stiff and that was probably the root of my 12 gram piercing issues, but I still have the cut down ones in my PGPs because I haven't needed to change them out.