Looking to sale a Mini Orracle build with a bunch of Inception Design parts. I think I bought the body off MCB a few years ago, but I can’t remember. Marker is in really good condition. Has a few scratches, most noticeable is from the pump arm when it had a pump kit installed. Previous owner drilled a small hole in the back block, I assume it was for some sort of velocity adjustment. There are also scratches on the bottom of the back block, possibly from rubbing on a beaver tail. Only issue I’ve seen is the 3 way hisses a little when first aired up, stops after first trigger pull so I never messed with it. Parts list below 👇
Specs:
WGP Mini Orracle Body
AKA Sidewinder regulator
AKA Bolt and Bolt pin
Palmers LPR with knob
CCM Internals (Full lower tube kit)
SSC clamping Feedneck
Inception FLE Frame with trigger kit
Inception Ball Detent
Inception Mini Cocker Front Block
Inception Volumizer, Ram, and 3 way
Inception Pump and Timing Rods
Inception On/Off ASA
G10 Grips
Marker is timed but not chrono’d. Could use a little reg balancing to get to preferred performance. Asking $425 Shipped and PayPal’d to US Only. Comes as pictured, no barrel included. Will also come with a full Inception Designs Pump kit.
Specs:
WGP Mini Orracle Body
AKA Sidewinder regulator
AKA Bolt and Bolt pin
Palmers LPR with knob
CCM Internals (Full lower tube kit)
SSC clamping Feedneck
Inception FLE Frame with trigger kit
Inception Ball Detent
Inception Mini Cocker Front Block
Inception Volumizer, Ram, and 3 way
Inception Pump and Timing Rods
Inception On/Off ASA
G10 Grips
Marker is timed but not chrono’d. Could use a little reg balancing to get to preferred performance. Asking $425 Shipped and PayPal’d to US Only. Comes as pictured, no barrel included. Will also come with a full Inception Designs Pump kit.
Attached Files
Comment