Complete Delta 68, with with a CCI Pierce pin.
I noticed pretty quickly the pierce on this thing was trash, some weird combo of o-rings and wave springs that blew out no matter what. So I tapped the valve plug for a CCI Pierce pin. It plain works.
With some old paint, it shoots at working velocity and cycles just fine, and everything stays in place when you change 12g. I got the quarter-turn bolt pull working, too. I was looking forward to trying this at the field... but it's been about a year since I've played, and I'm neck-deep into another project, and I accidentally won an auction on a drill press, the day after buying a drill press. I should remember what I bid on before buying stuff.
So, it's for sale. Given the challenge of finding one of these that works, and has both a feed tube and lever changer, I'm going to say $160 shipped, OBO.
Edit - $130 shipped.
I noticed pretty quickly the pierce on this thing was trash, some weird combo of o-rings and wave springs that blew out no matter what. So I tapped the valve plug for a CCI Pierce pin. It plain works.
With some old paint, it shoots at working velocity and cycles just fine, and everything stays in place when you change 12g. I got the quarter-turn bolt pull working, too. I was looking forward to trying this at the field... but it's been about a year since I've played, and I'm neck-deep into another project, and I accidentally won an auction on a drill press, the day after buying a drill press. I should remember what I bid on before buying stuff.
So, it's for sale. Given the challenge of finding one of these that works, and has both a feed tube and lever changer, I'm going to say $160 shipped, OBO.
Edit - $130 shipped.
.
Comment