Early 1990's RF minicocker - Green

[Hellion360]

Has the classic mods of the era.
Lug adjustment hole
Wire detent
Hammer lock screw hole
Mini cut

This mini cut is raw underneath the front block. The cut poked into the screw hole, looks like they were extending the air chamber at the same time. This is patched. If you wanted to anodize the patch would have to be removed and then resealed. But you aren't going to anodize this one. Some minor flake on the nickel here and there. But looks good overall.

Back block is 2K spec but looks like a pre-2K. Quite light.
Bolt is a Freeflow Delrin.
Barrel is a LAPCO stainless, freak bored.
Setup with a merlin IVG, can adjust velocity off the regulator with no issue. Goes right up to speed with a good paint match.

Medium/Light springing. Shoots pretty damn good.

$350 shipped

[Morgenstern]

Those old Colin Thompson era Lapco stainless barrels have to be the most over-built bit of paintball hardware ever. They're a work of industrial art.

[Hellion360]

They are indeed sturdy.
Shoot great though, maybe because they are so heavy. Keeps a line well.

[Hellion360]

Still kicking