PTP Micrococker autococker -

[mueller]

SOLD SOLD SOLD @420 heh heh

I'm unsure on value so input welcome
I'm fine to pull the frame ($35) and barrel ($10) if not wanted


Cosmetic:
Overall pretty good. Body shows wear on back edges, sled looks good on bottom and is slightly ovaled on the left side pin hole. Pneus show typical wear.

Functionality
I haven't tested/used and assume it'll need a full going through.
Yes the hoses are reversed -- it needed a frame, I had a slider around, it likely needs to be serviced anyway so I just slapped frame on.

[MrKittyCatMeowFace]

Only thing missing is a crazy ano job!

[Jonnydread]

and a cute little pump kit

[RuleOfSines]

Hnnnnnnnnngghh, going to try and forget I saw this

[Painthappy]

Man... Must not. Have too many projects. But keep it black. I love that look. Just needs a single trigger.

[RuleOfSines]

I have failed to forget, PM'd

[Painthappy]

I have failed to forget, PM'd

I'm glad it was you before me!!! Please take note that I'm back in the thread looking and drooling again.

[RuleOfSines]

I was googling images of PTP Micros while trying to forget (as we know, obsessively googling your obsession is the best way to forget it), and found this article on Bacci's site:

https://paintballhistory.com/medusa-sling-frame-autococker-automag-by-ptp-benchmark/

Reminded me that I actually have a PTP Medusa Sling frame prototype here that needs to go on something.

[XEMON]

I came back hoping someone broke before i did 😅

[mueller]

ya'll are thirsty for these indeed, RIP my message box it's been a ticker tape all day

and she's SOLD

[Ecapnation]

Welp.... Glad I didn't see this yesterday