GoG ENMY with CP Barrel

[zinger565]

GoG ENMY with stock and CP Barrel. Holds air and cycles. Not much else to say. Fairly good condition.

$100 and very OBO. Get it out of my basement.

[MrBarraclough]

With that being a 1st gen body, it would help to check on the valve. The early 1st gen valves had a problem with the body cracking. This was later solved by adding a metal reinforcing plate. All 2nd gen eNMys have the newer valve, and a lot of 1st gen ones got them (or got refitted with them) too. If you separate the body and frame and look at the valve from below, the reinforcing plate will be visible. It's just a round bit of stamped sheet steel with a couple of tabs on the sides for screw holes and a hole punched out of the center for the valve mechanism. The older style valves are just all black plastic.

[zinger565]

With that being a 1st gen body, it would help to check on the valve. The early 1st gen valves had a problem with the body cracking. This was later solved by adding a metal reinforcing plate. All 2nd gen eNMys have the newer valve, and a lot of 1st gen ones got them (or got refitted with them) too. If you separate the body and frame and look at the valve from below, the reinforcing plate will be visible. It's just a round bit of stamped sheet steel with a couple of tabs on the sides for screw holes and a hole punched out of the center for the valve mechanism. The older style valves are just all black plastic.

Ah, I knew there was something about the different versions. I'll get a Pic tonight. It airs up and cycles fine, but good to know.

[80F100]

Pm sent