Neat project, havin trouble

[ramagupa]

**Just the body and guide rods left*

Copper CCM handle - 100
Dust Black S6 plate - 50
System X Body (11/16 bore, 2k counterbore, vasa drilled for guide rod) - 225 with machining cost
Brand new ID 11/16 valve and master spring kit - 70

total invested $450ish

i cant get the marker to tune where i like it. Right now stuck at 230fps….

my loss your gain

285 shipped obo

[iamthelazerviking]

What does 2k counterbore entail?

[ramagupa]

The front 2k threads were drilled out to accommodate for the oring on the ccm s6 guide rod

[Araphel]

Is it possible that having the main guide rod set so much farther back in the body than normal is blocking off the VASA inlet holes?

[ramagupa]

I can double check. But its a shorter guide rod thats used like in the ccm markers

[Araphel]

Ok, didn't know it had the shorter rod.

[ramagupa]

Is it possible that having the main guide rod set so much farther back in the body than normal is blocking off the VASA inlet holes?

there are two vasa air holes. Half of the front hole is blocked. The rear hole is 100% clear

[ramagupa]

Price drop 250