WTT Automag ULE Rail

[djsubert]

SOLD!

I have up for SALE (*edit*) a very clean Dust Black Automag ULE rail. I would rate it 9.0/10 for condition. Please see attached pictures. You'll find general pictures + close-ups of the minor nicks in the anodizing. You'll also notice a little "science" occurred on the rail to fit a single hole foregrip. These modifications aren't seen when mounted up and the factory 2-hole ASA mount has been un-affected and still functional. The sear pin will be included, just didn't make the pictures after light cleaning.

Asking $85.00 PPL/G&S/Shippe

Thanks!
djsubert

[djsubert]

TTT

[capedcrayola]

If you want to sell it, please let me know.

[djsubert]

You get first dibs if I decide to sell.

[tunaman5]

I have a bunch of the original PK Gloss black Emag rails. None are perfect and have a few nicks but as good as one could expect from 20+ year old parts. I am sure I could mill one out for you. Gimme a few days...

[djsubert]

Sounds great! Let me know where you end up.

This is for the eMag you installed a tuna-blade and updated the software on a few years back.

[djsubert]

Can you also add milling for a warp left body? That would give me a couple options between my RT-Pro (profile pic) and eMag setup.

Thanks!

[tunaman5]

Warp left ULE Body or powerfeed body?

[djsubert]

Great question.

Warp left (driver’s side), ULE body.

Thanks!

[SwinGenX]

I have a bunch of the original PK Gloss black Emag rails. None are perfect and have a few nicks but as good as one could expect from 20+ year old parts. I am sure I could mill one out for you. Gimme a few days...

Not looking to hi-jack thread, but I am in the market for a ULE Emag rail as well. I will PM you tuna.

[djsubert]

Updated trade request to FOR SALE.

Thanks in advance Tuna for the milled eMag rail!

[djsubert]

To the Top

[djsubert]

Sold!