Carbon Fiber Tube

[talfuchre]

Here's another project from the parts collection that I always intended to finish but never quite got around to.

I have two carbon fiber tubes and three custom-turned, anodized aluminum components that were intended to make a T-handle assembly.

The original idea:

• The longer carbon fiber tube would serve as the main shaft.
• The shorter tube would attach perpendicular to it, forming a T-handle.
• Two decorative anodized end caps would finish off the handle.

Approximate dimensions:

• Carbon fiber tubing: ⅝" diameter
• Length: Approximately 14" each
• Three turned and anodized components included

Everything is being sold together as an unfinished project, as pictured. Some additional fitting or fabrication may be required to complete the assembly.

I can provide more detailed measurements or additional photos if anyone is interested.

$50 shipped, or make me an offer.

Thanks for looking!


TF

[bush_hog]

Was this to make a custom stock or something?

[talfuchre]

It was. Just never got to it - and then sold the Phantom I was putting it on.

[bush_hog]

Very interesting. I wonder how hard that tube is to cut and or drill without ruining it

[talfuchre]

Very interesting. I wonder how hard that tube is to cut and or drill without ruining it

VERY easy - with a dremel cut off disk - be careful for carbon strands - and sand clean. No worries.