Tried to figure out a value without much luck, so let’s do $550 and see what happens. No trades
- scratch built for me about 5 years ago
- .685 with wedgits, spiral ported
- Dropout for 12 gram
- breach is cut for FSR, but the bore isn’t really FSR friendly. I thought it looked better and gives a little more room to drop a paintball in
- Sheridan air gun trigger group and stock. Haven’t seen this one on a paintball gun before, but it works well and has a functioning safety
- the bolt is all brass, and uses the PPS flat O rings. It has a little hidden spring loaded ball that presses on the lower tube, and helps to keep it locked in place
there are a few quirks. The RVA is one of the angled ones, which with a bolt action, doesn’t give a ton of adjustability. If it’s backed out too far, the bolt hits it. If i was keeping it, i would tap the rear of the trigger group and do a proper, rear Allen screw RVA, and just remove the angle tapped screw. The gun was also shooting super hot when I got it. Like 350+. With the RVA issue, i couldn’t back it out enough. So i clipped the main spring. Last time i played with it a few years ago, it shot field velocity fine, but it would probably benefit from a new, lighter main spring, especially if you keep the RVA the way it is
pics: https://imgur.com/a/bUjjesx
- scratch built for me about 5 years ago
- .685 with wedgits, spiral ported
- Dropout for 12 gram
- breach is cut for FSR, but the bore isn’t really FSR friendly. I thought it looked better and gives a little more room to drop a paintball in
- Sheridan air gun trigger group and stock. Haven’t seen this one on a paintball gun before, but it works well and has a functioning safety
- the bolt is all brass, and uses the PPS flat O rings. It has a little hidden spring loaded ball that presses on the lower tube, and helps to keep it locked in place
there are a few quirks. The RVA is one of the angled ones, which with a bolt action, doesn’t give a ton of adjustability. If it’s backed out too far, the bolt hits it. If i was keeping it, i would tap the rear of the trigger group and do a proper, rear Allen screw RVA, and just remove the angle tapped screw. The gun was also shooting super hot when I got it. Like 350+. With the RVA issue, i couldn’t back it out enough. So i clipped the main spring. Last time i played with it a few years ago, it shot field velocity fine, but it would probably benefit from a new, lighter main spring, especially if you keep the RVA the way it is
pics: https://imgur.com/a/bUjjesx
Comment