Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
I knocked the feed neck off and cut and filed the hole left behind. The barrel is a perfect bore for FSR. No need for rifling, the fins will put the proper spin on the round since it is a very slight overbore (I used a piece of electrical tape as a detent and could run, barrel down, with a round chambered
Edit: I also didn’t have a pump handle so I just used the lug on the bolt to cock it. (it was a lot of fun to play with…I have it away for a Walzmas in July fundraiser)
Comment