PMI Trracers

[Grumpy7]

4 PMI Trracers
3 without adjusting bolts.
1 with adjustable bolt (shorter barrel)
All were cleaned and rings replaced. Air up with no leaks. Have not chronod as I have other Trracers I use.
With adjustable bolt $95 shipped in US.
Without $75 shipped in US.
Will ship USPS flat rate so if you want more than one can knock off $20 and ship together
These are old and not perfect.

[OpusX]

These are old and not perfect.

Just like the rest of us Thats the most MCB thing I've read today.

[drewkroeker]

Question for you: have you ever had issues screwing or unscrewing the barrels on these? I recently got a trracer from ebay and the shank of the barrel was very tight screwing it in. It did not want to fit into any of the trracer spacer that I bought from DocsMachine either. I ended up using fine grit sandpaper and sanding it down a little bit. If I didn't sand it it probably would have gotten stuck.

[Grumpy7]

Question for you: have you ever had issues screwing or unscrewing the barrels on these? I recently got a trracer from ebay and the shank of the barrel was very tight screwing it in. It did not want to fit into any of the trracer spacer that I bought from DocsMachine either. I ended up using fine grit sandpaper and sanding it down a little bit. If I didn't sand it it probably would have gotten stuck.

Have never had that problem with any of the Trracers I've owned, and that includes some aftermarket barrels I have. I've have seen that with some other markers but never thought to much of it, just never used the barrel that fit tight for fear of getting them stuck.

[DocsMachine]

The breech of a Trracer barrel is very thin- almost as thin as a Freak insert. It's not at all out of the question it got bent slightly and is out-of round.

Doc.

[Grumpy7]

Bump