Sheridan KP1-ish FS

[JJohnson]

Picked this up a long time ago, got a repro K1 stock, added a bolt handle, brass trigger guard, and front sight.
Has an extra spot for a air line? in the bottom tube.
It does currently leak out the whole 12ie when pierced, so it will need new seals.
I will include a Sheridan valve tool with it.

$475 shipped and Paypal - SOLD


Digging this out reminded me I had a great headshot with it on video years ago.

https://youtu.be/MA9psjV6G7s

[jeramiej]

Nice brass. Have always liked that video. Might be why I have 4 bolt-action KPs.

[JJohnson]

Bump

[Chemical-x.....ahain]

when the seals are good does it have decent efficiency and shoot around 280 FPS?

[chplnstone]

nice, clean k1. vent valve on bottom isn't intended as a constant air line, but to vent the co2 before swapping 12 grams (iirc they initially ran dual 12vies), many were adapted to bulk fill. I have a few spare stock trigger guards if the buyer's interested. where'd you get the repro stock?

[JJohnson]

Repro stock was here on MCB years ago, can't remember who did a run of them, but it must have been about 15-ish years ago.

nice, clean k1. vent valve on bottom isn't intended as a constant air line, but to vent the co2 before swapping 12 grams (iirc they initially ran dual 12vies), many were adapted to bulk fill. I have a few spare stock trigger guards if the buyer's interested. where'd you get the repro stock?

[JJohnson]

If I remember correctly, it was 25ish shots and I usually ran it at about 265fps. It does have a velocity adjuster in the trigger group.

when the seals are good does it have decent efficiency and shoot around 280 FPS?

[Chemical-x.....ahain]

was the adjuster maxxed out at 265?

[JJohnson]

was the adjuster maxxed out at 265?

No, it still had more adjustment yet

[vinguy]

Are seals for these hard to come by? And does replacing them require any special tools?

[Hutbrew]

PM’d about a local pickup

[JJohnson]

Someone else would have to chime in, it has been 15 years since I ordered a kit and rebuilt one.
It does require/it helps to have a valve tool, but I have one that I could include since this is currently my last Sheridan marker.

Are seals for these hard to come by? And does replacing them require any special tools?

[Chemical-x.....ahain]

I apologize for the delay in communication. I have funds on standby

PM sent.