Got this in a lot and have no interest in fixing it up. Selling as is; all I've done is clean off the surface corrosion and paint and remove the urethane orings before they were complete gum. Assume all orings need to be replaced. Would probably make a fun, cheap little electro shooter since the trigger is decent (just hold on for the ride).
The good: board turns on and the sear trips, but I think this needs a 9.6v to drop the hammer because it wouldn't do that with just a 9v. Eyes work and I pressed the button a few times and it went into some sort of ramp mode. No clue what it has or if all functions are there, but the most important ones are there. Barrel is a 14" Tiller.
The broken: right side eye cover is broken as is the cover of one button. All the screws and other hardware have some level of corrosion. Barrel exterior has quite a bit of wear but the bore is fine. It was cocked back when I got it so I have no idea what kind of condition the spring is in (normal Spyder springs fit).
The missing: missing a detent (ion nub style), feedneck (Impulse thread) and I think there's supposed to be a spring behind the ball for the quick strip pin in the bolt (works fine without it).
Looking for *SOLD* $15 USD *SOLD* plus shipping (from Canada) OBO. Any questions please ask.
The good: board turns on and the sear trips, but I think this needs a 9.6v to drop the hammer because it wouldn't do that with just a 9v. Eyes work and I pressed the button a few times and it went into some sort of ramp mode. No clue what it has or if all functions are there, but the most important ones are there. Barrel is a 14" Tiller.
The broken: right side eye cover is broken as is the cover of one button. All the screws and other hardware have some level of corrosion. Barrel exterior has quite a bit of wear but the bore is fine. It was cocked back when I got it so I have no idea what kind of condition the spring is in (normal Spyder springs fit).
The missing: missing a detent (ion nub style), feedneck (Impulse thread) and I think there's supposed to be a spring behind the ball for the quick strip pin in the bolt (works fine without it).
Looking for *SOLD* $15 USD *SOLD* plus shipping (from Canada) OBO. Any questions please ask.
Comment