GOG eNMEy w/ 14" Proto Barrel

[Toestr]

It's an early first gen (breach is still cut for eyes). It's in good condition with just the normal little marks here and there. You may want to replace the ASA because my tank reg (new Ninja pin valve with brass bonnet set to 600psi) was a bit tight, but it does work. It comes with a 14" Proto one piece barrel. I'll also throw in a Proto Primo hopper for free if you'd like. It airs up and dry fires fine, but I will do a shooting test tomorrow and update.

It just had a fresh oring rebuild. It's mostly factory spec orings but all static seals were changed to buna/HNBR. The detents were also just replaced and the reg seat looks pristine.

Looking for *SOLD* $100 CAD *SOLD* plus shipping (from Canada). Any questions please ask.

[Psycho91]

To bad this isn't a 2nd gen or had an HE valve

[Toestr]

Yeah rip.

[MrBarraclough]

So this just has the original Mk1 valve with the all-plastic body and no reinforcing plate?

[Toestr]

That's correct.

[Toestr]

A bit of retrospective on this; I think the only reason the metal plate was added was because a) people would go incredible hulk on the trigger causing the valve to crack and leak and b) people would go incredible hulk on the valve screws causing it to crack and break. In terms of performance I think it is identical to the reinforced (HD) valve.

[Toestr]

Ok, so I shot it today. When I first aired it up it sounded like it fired a couple times upon initial air up then had a slight leak from the valve for a few seconds before it sealed up. I'm not sure what that was about but I tried to recreate it a few times and it wouldn't do it. I then fired it roughly 100 times with no issues at 280 fps. I opened up the valve after and everything was fine. I then re aired it up and dry fired a few dozen times and again it was fine. So I don't know what that was all about.

I actually liked shooting this more than I thought I would. I think that was the fastest I've ever shot with a mech gun and it was super consistent (even with crappy paint). I like it better than my Emek. I'll definitely pick up another one of these in the future.

[ChoSanJuan]

I've always felt this between my eNMEy and Emek. Both have their merits, but I can rip harder and faster with my eNMEy, even with a FL 3way, Secret Pin, and Murder Machine trigger.

[Toestr]

Yeah I'm glad I got an MG100 over a regular Emek. It gives me many more options.

[Toestr]

Big bump on this. I took it out today and put about 500rds though it and it shot like a champ. Great lightweight little shooter.

[Toestr]

Up

[JoeSchitt]

Sent a PM

[NormG]

I'm in southern Ontario, I might be interested.

Is that a stock Proto barrel? I would've thought those would be the wrong thread for that marker (autococker threads.)

[Toestr]

Nope, Proto made aftermarket barrels too. This is Impulse/Ion threaded.

[Sicksthree]

I had one of these 1st Gen’s for a little while. Upgraded to the Repair trigger. It served me well. Gave it ti my friend and has been a workhorse for years.
Bump for a great deal

[Toestr]

Bump

[Toestr]

"Buy me."

[Toestr]

Canada Post is probably going on strike again. Get it soon!

[Toestr]

SOLD