PLEASE READ - Unable to get any meaningful FPS out of it. The bolt cycles just fine and it airs up to ~200psi with no recharge issues, but between two ~850psi HPA tanks (pin and ball valve), I don’t think it was shooting any more than ~10FPS. Have tried replacing the poppet entirely, going over every engine oring, the check valve, as well as trying different fresh batteries. I'm inclined to think its a ASA/reg issue at this point, but kinda at my witz end otherwise and just want to stop fiddling with it. I can send a video of the behavior in a DM.
The good: Has an upgraded proto feedneck, brand new v4 poppet, and a thumb screw was added for the battery door. A secondary trigger magnet was added as well for a slightly crisper pull & return. Comes with a new 9v & the original manual, albeit appears to be paint stained throughout the first and last few pages (not by me, I swear!). Also comes with a Lapco "Desert Edge" 2 piece 14" barrel with a .687 back, as well as the stock 12" barrel.
The bad: Fairly scratched up, especially for the rear screw area, see pics. The power button is finicky; It ultimately seems to respond the most consistently if pressing on the upper portion of the button. Also, this has the old Optimus board, not a Shockwave. Missing 1x ASA set screw (10-24 x 1/4in, Part #17557). The front grip jewel was missing so has been replaced with a 3d printed TPU piece as well.
$65 shipped via PayPal G&S, or $50 if meeting locally in NC. Price firm, no haggling please. Will have it shipped out within 1-2 days of being paid.
SOLD SOLD SOLD SOLD
The good: Has an upgraded proto feedneck, brand new v4 poppet, and a thumb screw was added for the battery door. A secondary trigger magnet was added as well for a slightly crisper pull & return. Comes with a new 9v & the original manual, albeit appears to be paint stained throughout the first and last few pages (not by me, I swear!). Also comes with a Lapco "Desert Edge" 2 piece 14" barrel with a .687 back, as well as the stock 12" barrel.
The bad: Fairly scratched up, especially for the rear screw area, see pics. The power button is finicky; It ultimately seems to respond the most consistently if pressing on the upper portion of the button. Also, this has the old Optimus board, not a Shockwave. Missing 1x ASA set screw (10-24 x 1/4in, Part #17557). The front grip jewel was missing so has been replaced with a 3d printed TPU piece as well.
$65 shipped via PayPal G&S, or $50 if meeting locally in NC. Price firm, no haggling please. Will have it shipped out within 1-2 days of being paid.
SOLD SOLD SOLD SOLD
Attached Files
Comment