WTB: MR1 Rear Body Pin and Velocity Adjuster Plug Assembly

[infamoussmiley]

Hello Folks,

I have project MR1 on the bench that needs parts. I have everything except the main spring, the Rear Body Cross Pin and the Velocity Adjuster Plug Assembly. Help

Best,

Smiley

[infamoussmiley]

Still looking

Best,

Smiley

[Rolling Thunder 67]

ANS gear has what your looking for under the MR100's most of the MR100 components cross over to the MR1, and the parts you mentioned are drop ins.I recently orders what your looking for and a couple more pieces to help complete 2 of the 7 MR1's in my stable. if you use the front plug for the lower tube from an MR100 it will need a longer spring and a hole and tap relocated as it is flat and doesn't have the post milled on it for the spring to locate like an MR1 Plug. it is about the only piece that doesn't cross over as a drop in. bolts may be different for detent location. Good luck with your Build.
RT 67

[infamoussmiley]

ANS gear has what your looking for under the MR100's most of the MR100 components cross over to the MR1, and the parts you mentioned are drop ins.I recently orders what your looking for and a couple more pieces to help complete 2 of the 7 MR1's in my stable. if you use the front plug for the lower tube from an MR100 it will need a longer spring and a hole and tap relocated as it is flat and doesn't have the post milled on it for the spring to locate like an MR1 Plug. it is about the only piece that doesn't cross over as a drop in. bolts may be different for detent location. Good luck with your Build.
RT 67

Very cool. I will look into this.

Best,

Smiley

[SETHZILLA!]

I may have these parts. If you don't buy them from ANS, hit me up and i can check for you.

Sent from my SM-G970U1 using Tapatalk