Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
They haven't been gone through since you posted them, have they? Do you know if the valves are the later version that work with compressed air?
Since I'd probably need to rebuild the valves, I'd need to know if they can be taken apart with regular snap ring pliers or if they have horrible C rings that need a surgeon to get apart without breaking.
It's pretty rare to find one that is the older floating valve style. I'd be confident that these are the newer style.
It's the same style front ring that was in the 98c for years. I've found that if you use a pencil eraser to hold them in place, then slip a pocket knife under the edge of the ring you can get them out pretty easily.
I actually air them up when I posted and couple months back. Using air not co2. 1 does have a leak, the other no leaks and cycles fine. I have not pulled the valve to check, i can do that this weekend and get you pictures if you like.
Comment