Dead 2011 Rail/Rize/CZR solenoid board

[lhamilton1807]

*May 2025 - still need 4 more of these*

I am in the market for a 2011+ Dye Rail/Rize/CZR solenoid. I don’t need a working solenoid or board, and don’t need the hoses or fittings - solenoid cap m, armature disc, & screws without the other bits is just fine.

The only requirements are that (1) the cap isn’t cracked or leaking and (2) it’s the style that is shown in the attached picture. Apparently some of them were black, not light blue. Should be fine either way.

Edit: Willing to consider an entire nonfunctional Rail/Rize with a dead board if that’ll get me the solenoid I’m down for a mech project

[Sdawg]

I have one I don't need, send me a DM

[lhamilton1807]

Sent

[lhamilton1807]

Still looking - didn’t want to butcher a working solenoid

[Rickfactor2]

Any interest in an entire gun?

[lhamilton1807]

Maybe… does it have a dead board or bad solenoid? I don’t actually want to butcher a working rail or Rize to get an eXTCy working.

[Rickfactor2]

It's been sitting for awhile. Will have some time to test this week. Mint in outside appearance.

[lhamilton1807]

Found a dead noid - confirmed this will resurrect a GoG blackheart board

[lhamilton1807]

And I’m back to needing 4 more of these. Have a small herd of SP/GoG to resurrect

[I Missed On Purpose]

I have a black one, it works but front banjo fitting has a leak where hose came unglued

[lhamilton1807]

I only need the noid cap and screws, so leaking banjo fittings don’t matter. PM inbound