WTB Brass freaked AC barrel, Sliders, FT1/2 body kit

[warbosschoppa]

Still looking for a brass AC barrel that's freaked for 5"

Loaded black slider that is one of the following
Bob Long humpback, Kapp Groovy, Belsales Angry, Bob Long Ironmen lasered

And an Eclipse FT1/2 body kit (must have ram mount, banjo plug, vasa, back block)

[Jordan]

I think it might be tough to find a Freak'd brass barrel, most of them are too thin to bore out.

[Jordan]

warbosschoppa PPS uses barrel tube that's nearly identical to stock Sheridan tube, which is ~.815" or so OD. If you bore that tube to .745" to accept Freak inserts you end up with a tube that has a wall thickness of roughly 0.032", or the same thickness as a Freak insert.

Not quite paper thin, but not very sturdy either.

[warbosschoppa]

Dang, maybe a BOA brass would work. Otherwise get a custom back made.

[chplnstone]

basically, if you freak bore stock sheridan barrel tube the sidewall is the same thickness as ammo tube... might be easier to simply solder the threaded base on a piece of ammo tube with thinwall barrel soldered in the tip (I've been meaning to get around to doing this for both my cocker & pmi3's). if you're worried about wall thickness you can also solder an additional sleeve around the outside