Hard to find parts...

[BrendanB]

Yeahlooking for:

eclipse FT front block (see picture)
evo shroud (see picture)
belsales red wire beavertail
AA spiral hole freak tip blue
belsales evo lpr
wgp twisting sto feedneck
cheap pre-2k bolt
nummech cocker detent

[BigRed]

I have a couple Pre 2K bolts I can part with. One is stock and the other is a blue ANS Venturi.

[BrendanB]

I have a couple Pre 2K bolts I can part with. One is stock and the other is a blue ANS Venturi.

pm me how much you want for the venturi

[BigRed]

Pm sent

[Chuck E Ducky]

Nummech detents Suck BTW

I had two of them self detonate after a days play.

I found one of them and put it back together but I don’t trust it enough to sell them. They are not built properly. I’m afraid they will mess my bolt up. I think the inception ones are way nicer and you can Ano them to Mach.

Outside of there frames there products kind of blow.

[BrendanB]

Nummech detents Suck BTW

I had two of them self detonate after a days play.

I found one of them and put it back together but I don’t trust it enough to sell them. They are not built properly. I’m afraid they will mess my bolt up. I think the inception ones are way nicer and you can Ano them to Mach.

Outside of there frames there products kind of blow.

did you loctite the threads into position on the inner sleeve. I’ve used them a ton and never had problems.

[Chuck E Ducky]

Nope didn’t know I had to. Realized that after they detonated down my barrel at 280fps. They came together and were already anodized. You would think if that was a requirement they would leave a note or send them un assembled. Im pretty unimpressed with there products. Gas in grip frames are cool but functionality are meh. Lots of leaks and a nightmare to get setup. Feedneck I bought cracked installing it due to being paper thin. I wrote them off a this point. Not much in stock there these days anyway.

[BrendanB]

the necks are very dainty for sure. Definitely not diving with a nummech neck on my gun.