Question: Has anyone Single Triggered an E Blade frame?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Loophole
    MCB Member
    • Feb 2021
    • 1427
    • California
    #1

    Question: Has anyone Single Triggered an E Blade frame?

    Would love to see it.
    Last edited by Loophole; 03-17-2021, 09:14 PM.
    Feedback: https://www.mcarterbrown.com/forum/b...ole-s-feedback
    Tags: None
    • Señor Leo
      Here since 09 pre-hack
      • Jul 2020
      • 55
      • San Diego
      #2
      I have seen one. It may have been the guy that runs RKJ paintball, but Im not absolutely sure.

        Comment

        • Alexndl
          MCB member
          • Jul 2020
          • 3508
          • Montreal, Qc, Canada
          #3
          If you use a MQ valve it make things a lot easyer, MQ valve remove the sear and hammer so its just a mather of finding a frame and fit the board in and make sure you can fit the holes pattern.
          I compared an eblade and angel frame and they are very similar so I guess you could use a dye single finger angel frame and adapt it. But not sure how to make the trigger work
          Last edited by Alexndl; 03-18-2021, 08:47 AM.
          💀Team Ragnastock💀

            Comment

            • OpusX
              #3.1
              OpusX commented
              03-18-2021, 08:44 AM
              Editing a comment
              Someone was selling an MQ setup with a single finger Angel frame recently...
            • Alexndl
              MCB member
              • Jul 2020
              • 3508
              • Montreal, Qc, Canada
              #4
              OpusX
              Just found the post you mentionned, still available
              https://www.mcarterbrown.com/forum/b...ngs#post106451
              💀Team Ragnastock💀

                Comment

                • Kit
                  MCB Member
                  • Jul 2020
                  • 452
                  • Cali
                  #5
                  I have tried nd failed. I will try to make a frame from scratch next.

                    Comment

                    Previous template Next
                    Working...